From raw board to ready panel.

Our lamination machine bonds decorative film onto any flat board with PUR glue, heat and pressure. Every panel comes out flat, sealed and ready to cut.

Live line

Watch the film go on.

01Board feeding

Raw boards are sanded, dusted and fed onto the conveyor.

02PUR glue coating

A roller spreads an even, thin coat of moisture-resistant glue.

03Film lamination

Decor film is pressed onto the board under heated pressure rollers.

04Trim, cure & pack

Edges are trimmed and the panels cured, inspected and stacked.

Stack of MDF, PVC hollow sheet, plywood and particle board with PVC film being applied

Any core panel

One line. 16 boards.

Particle board: flat, economical carcass and wardrobes
MDF: smooth surface for routed and profiled shutters
HDHMR: high density and moisture resistant, for kitchens
Plywood: strong screw-holding for heavy furniture
WPC board: waterproof and termite-proof
PVC foam & hollow sheet: lightweight and 100% waterproof
Block board & HDF: long shelves, back panels and drawer bases
Ceiling tiles, calcium silicate, fibre cement & MgO: wall and ceiling cladding
ACP, honeycomb & flush doors: specialty boards and ready doors

Configure a panel

Quality checks

Checked before it ships.

Peel strength

Film bond tested on samples from every batch.

Shade consistency

Every batch is checked against a master sample under daylight lamps.

Flatness

Panels are checked for warping before they're stacked.

Surface defects

No bubbles, dust spots or wrinkles pass inspection.

Edge sealing

Edges are trimmed clean for edge-banding.

Safe packing

Protective film and corner guards on every bundle.